Tektronix TDS3000 Manual de usuario Pagina 115

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 140
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 114
Maintenance
TDS3000 Series Service Manual
6–39
Measure voltages on
disconnected cable as shown in
diagram at right.
Power off oscilloscope.
Disconnect AC power cord.
Reconnect J100 cable to the
battery board.
Disconnect J900 cable from the
main board.
Connect AC power cord.
Power on oscilloscope.
Replace the Battery
board module.
No
Yes
Are voltages within
tolerance?
Power off oscilloscope.
Disconnect AC power cord.
Reconnect J900 cable to main
board.
Connect AC power cord.
Power on oscilloscope.
Measure voltages on
connected J900 cable as shown
in diagram at right.
Power distribution problem
on main board, front panel
board, or display. Proceed
to Figure 6–28.
No
Yes
Are voltages within
tolerance?
Power distribution OK. Proceed to
module isolation troubleshooting
(Figure 6–31).
Continued from Figure 6–26.
Pin 1
Pin 1 J900
Main board
Connector DC Voltage
1 Gnd
2–4 5.1 V 0.15 V
5 Gnd
8 –15 V 1.2 V
9 15 V 1.2 V
10 Gnd
12 ~+5.5 V (disconnected)
~+3 V (connected)
Cable from
battery board
Pin 12
Figure 6–27: Battery module troubleshooting procedure
Vista de pagina 114
1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 139 140

Comentarios a estos manuales

Sin comentarios