Tektronix P H A S E R Phaser 840 Manual de usuario descargar pdf (Pagina 61)

Setting the Printer’s IP Addressing Parameters

Setup Guide

Running the

conﬁg-IP

script

Connect the printer to a network. ARP (Address Resolution Protocol)

requires that the printer be connected on the same physical network

segment as the host.

Run the script conﬁg-IP:

In the directory where you placed your printer’s network utilities,

change (cd) to the bin subdirectory.

Type the name of the script, redirecting the output to a ﬁle. Type:

conﬁg-IP > ﬁlename

Enter the information when prompted by the script.

Make an entry into the host’s ARP table deﬁning the printer’s

IP/hardware address pair. In general, this requires a command

corresponding to one of the following examples:

arp -s printer-IP-address hardware-address (for BSD systems)

arp -s ether printer-IP-address hardware-address (for System V)

See your host system documentation for speciﬁcs of this command.

Turn on the printer.

The script accepts IP addresses that have empty ﬁelds (for example,

123..40.10). The script does not detect this error. Double-check the IP

addresses you enter.

The hardware address in the arp command example is the printer’s Ethernet

Address for PhaserShare Ethernet interfaces or the Token Ring Address for

PhaserShare Token Ring cards.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 71 72

Sin comentarios

Tektronix P H A S E R Phaser 840 Manual de usuario Pagina 61