Tektronix Phaser 600 Manual de usuario descargar pdf (Pagina 504)

CONNECTING A SCSI HARD DISK

Phaser Copystation:

■ If you have a Phaser Copystation connected to the printer, it must be

located at one end of the SCSI chain, with the printer at the other end

and the external disk(s) in the middle.

■ The Copystation uses two SCSI ID addresses, 5 and 6; therefore, the

external disk(s) can use ID numbers 0 through 3. If you set an external

disk to SCSI ID address 5 or 6, you may see an error on the

conﬁguration or startup pages.

■ You may load a startup ﬁle called

onto your external disk. The

job ﬁle is similar to an init ﬁle. When you turn on the printer

the ﬁle executes, providing that

has been enabled through a

control ﬁle downloaded to the printer. Refer to Enab

ling and disabling

SysStart Job execution for more information.

ﬁle contains an error, the printer ignores the remainder of the ﬁle and

may not start up as expected.

Sin comentarios

Tektronix Phaser 600 Manual de usuario Pagina 504