Tektronix Phaser 600 Manual de usuario descargar pdf (Pagina 630)

SYMPTOMS AND SOLUTIONS

Media skews Make sure that the ﬁxed end of the paper roll holder (the side

removable plastic nut) is installed at the side closest to the front panel.

Make sure that the media is installed so that it loads over the top of the roll.

Refer to the drawing on the previous page.

Make sure that the media is fed into the printer evenly.

To optimize the printer’s wide-format design, use cut-sheet media at least

B-size and/or roll media at least 16.5 inches wide for better feed reliability.

Make sure that the leading edge of the media roll is cut evenly (corners are

90˚) and smoothly. Refer to the illustration below. If your media is not cut

evenly, follow the instructions on Cutting roll media

Media does not

Clean the Dr

um, Feed rollers and paper guides, and Clamp rollers.

Media problems (cont'd.)

Symptom Solution

90° 90° < 90° > 90°

Sin comentarios

Tektronix Phaser 600 Manual de usuario Pagina 630