Tektronix 480X Manual de usuario descargar pdf (Pagina 102)

Front and Rear Panels

7-2

Phaser 480X Color Printer

Phaser 480X rear panel switches

Rear panel switches

Switch Function Settings

1 Reset/run

: The printer resets and does not accept data while

the switch is in this position.

Down

. The printer runs a self-test, then proceeds to run

normally. Leave the switch

down

for normal operation.

2, 3, and 4 Diagnostics

. When only Switch 4 is moved from

down

, the

printer prints a conﬁguration page.

Down

. Normal operation.

5 Start Job

: The Sys/Start job on the hard disk does not run.

Down:

The Sys/Start job runs if the ﬁle exists on the

disk.

6 Cleaning mode

Up:

At power-up, the printer rotates the rollers for a few

seconds, then stops the rotation. See “Cleaning the

printer” on page 4-5.

Down:

Normal operation.

7 Baud Rate

: Fixed. Sets the serial communication parameters

to 1200 baud, software ﬂagging, and ignore parity.

Down

: Variable. Lets you change the serial

communication parameters. The factory setting is 9600

baud, software ﬂagging, and ignore parity.

8 and 9 Color correction See table “Switches 8 and 9: Color Correction Mode” on

page 7-3.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 135 136

Sin comentarios

Tektronix 480X Manual de usuario Pagina 102