Tektronix TDS1000- Manual de usuario descargar pdf (Pagina 23)

Getting Started

TDS1000/2000-Series Digital Oscilloscope User Manual

Functional Check

Perform this quick functiona l c heck to verify that your osc illoscope

is operating correctly.

PASSED

OFF

button

1. Power on the oscilloscope.

Wait until the display shows that all

power-on tests passed. Push the DEFAULT

SETUP button. The default Probe option

attenuation setting is 10X.

CH 1

PROBE COMP

2. Set the switch to 10X on the P2200 probe

and connect the probe to channel 1 on the

oscilloscope. To do this, align the slot in

the probe connector with the key on the

CH 1 BNC, push to connect, and t wist to

the right to lock the probe in place.

Connect the probe tip and reference lead

to the PROBE COMP connectors.

3. Push the AUTOSET button. Within a few

seconds, you should see a square wave i n

the display of about 5 V peak-to-peak at

1kHz.

Push the CH 1 MENU button twice to

remove channel 1, push the CH 2 MENU

button to display channel 2, repeat steps 2

and 3. For 4-channel models, repe at for

CH 3 and CH 4.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 205 206

Sin comentarios

Tektronix TDS1000- Manual de usuario Pagina 23