Tektronix TDS500C Manual de usuario descargar pdf (Pagina 24)

Brief Procedures

1–8

TDS 500C, TDS 600B & TDS 700C Performance Verification and Specifications

connect the probe ground (typically black) to PROBE COMPENSA-

TION GND. If using a P6243 or P6245 probe, you may want to attach a

Y-lead connector and two SMD KlipChips as shown in Figure 1–3.

Signal Gnd

Figure 1–3: Universal test hookup for functional tests – TDS 600B shown

b. Initialize the oscilloscope:

H Press save/recall SETUP.

H Press the main-menu button Recall Factory Setup.

H Press the side-menu button OK Confirm Factory Init.

2. Verify that all channels operate: Do the following substeps — test CH 1

first, skipping substep a and b since CH 1 is already set up for verification

and as the trigger source from step 1.

a. Select an unverified channel:

H Press WAVEFORM OFF to remove the channel just verified from

display.

H Press the front-panel button that corresponds to the channel you are

to verify.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 147 148

Sin comentarios

Tektronix TDS500C Manual de usuario Pagina 24