Tektronix AWG710B Manual de usuario descargar pdf (Pagina 450)

100

101

Appendix B: Performance Verification (AWG710B)

B-18 AWG710&AWG710B Arbitrary Waveform Generator User Manual

e. Push 1, 0, 0 and M (SHIFT+7) keys in this order or turn the general

purpose knob to set the internal clock frequency to 100 MHz.

f. Push the RUN and CH1 output buttons.

The LEDs above the RUN button and CH1 output connector are on.

g. Push the FORCE TRIGGER button.

Verify that the oscilloscope displays sine waves while the FORCE TRIGGER

button is pushed and that the output stops when the Force Trigger button is

released.

4. Follow the substeps below to check the gated mode with the gate signal:

a. Set the oscilloscope trigger source to CH2 and change the trigger level to

1 V.

b. Turn on the function generator output.

c. Verify that the oscilloscope displays sine waves while the function

generator gate signal amplitude is High level. See Figure B-8.

Figure B-8: Relationship between gate signal and waveform output

d. Push SETUP (front–panel)!Trigger (bottom)!Negative (side).

This changes the AWG710B Arbitrary Waveform Generator trigger polarity to

negative.

5. Verify that the oscilloscope displays sine waves while the function generator

gate signal amplitude is Low level.

6. Turn off the function generator output and disconnect from the oscilloscope.

Waveform

output

Gate

signal

CH1

CH2

1 2 ... 445 446 447 448 449 450 451 452 453 454 455 ... 579 580

Comentarios a estos manuales

Sin comentarios

Tektronix AWG710B Manual de usuario Pagina 450

Comentarios a estos manuales

Relacionado con productos y manuales para Generadores De Poder Tektronix AWG710B